E-9661-6B190Q Seco-Larm Long-Range Barrier Sensor Six Pairs of Beams Black Enclosure

Features:

• Long sensor range up to 190ft (600m) outdoors, 380ft (120m) indoors
• Programmable for 4 different frequencies to reduce interference between multiple units
• Programmable response time (150/300/450/600 ms)
• Built-in heater (activates at 41^ºF (5^ºC))
• LED and buzzer alignment indicators
• For indoor or outdoor perimeter security
• End caps swivel for easy installation
• Programmable immediate trigger on simultaneous breaking of beams, or trigger after a single pair of beams is broken for at least 2 seconds

ENFORCER Long-Range Barrier Sensors are ideal for protecting indoor or outdoor areas separated by long distances. They feature reliable photobeam technology with a choice of four programmable beam frequencies that provide superior perimeter protection by eliminating crosstalk and interference when multiple units are used. False alarms caused by animals, falling leaves, poor weather, or other sources are minimized by programming the alarm output trigger operation.
ENFORCER Long-Range Barrier Sensors work in even the most extreme conditions. A built-in heater automatically turns on and off depending on the outside temperature. An environmental control system senses a slow degradation in beam strength when weather conditions worsen to help prevent false alarms.

Specifications

• Number of beams - 6 pairs
• Max. range outdoor - 190' (60m)
• Max. range indoor - 380' (120m)
• Voltage - 12~24VDC
• Tx standby & active current, heater off (+/-25%@12VDC) - 100mA
• Rx standby current (buzzer off),heater off (+/-25%@12VDC) - 95mA
• Rx trigger current (buzzer on) heater off (+/-25%@12VDC) - 95mA
• Buzzer active current (Rx only) - 20mA@12VDC
• Heater active current (Rx+Tx) - 160mA@12VDC
• Input voltage - 12~24 VDC
• Response time (receiver) - 150/300/450/600 ms (DIP switch programmable)
• Detection methods - Triggers as programmed when any 2 adjacent pair of beams are broken, or any single pair of beams is broken for over 2 sec. (programmable by JP2)
• Selectable beam frequencies - 4 Different frequencies (DIP switch programmable)
• Alarm output - NO/NC/COM, relay output, active for 1 sec. when triggered
• Tamper output (Tx & Rx) - 1A@120VAC / 1A@24VDC
• Alignment LED (Rx only) - Red LED, ON - beam is broken / OFF - aligned
• Alignment angle - Horizontal +/-90º
• Operating Temperature - -49º~131º F (-45º~55º C)
• Humidity - 95%
• Weatherproof - IP65
• Case - Aluminum housing / PC anti-UV cover / ABS end caps
• Length - 61" (155cm)
• Width x Height - 1-7/8"x2-1/4" (49x55 mm)
• Weight (Tx & Rx) with brackets - 12.1-lb (5.5kg)

E-9661-6B190Q Datasheet