Features:
- Monitors up to three zones per premises or vehicle, plus manual paging
- Connect to nearly any type of burglar alarm control panel, vehicle alarm, communications panel, etc.
- One positive and two negative instant trigger inputs
- Range: Up to one half mile (4W output)
- Over two million possible coding combinations
- Belt-clip receiver included
- Code-learning receiver learns up to three transmitters
- Color LEDs (Green, Orange, or Red) on the receiver indicate which zone of the premises or vehicle was triggered
Specifications
Transmitter
- # of codes - Over 2 million (factory pre-set)
- Power - 12VDC
- RF output power - 4W max.
- Current drain
- Standby - 10mA
- Active - 1A
- Frequency - 27MHz
- Antenna impedance - 50 Ω
- Range - Up to 1/2 mile in open air1
- Dimensions - 41/8x31/8x15/16 (105x79x33 mm)
- Weight - 5.1-oz (145g)
Receiver
- # of codes - Learns up to 3 transmitter codes
- Power - 3VDC (2 AAA batteries)2
- Battery life - Approx. 1 month3
- Current drain
- Standby - 1mAActive (Beep) - 20mA
- Active (Vibrate) - 50mA
- Dimensions - 3x21/8x5/8 (76x54x16 mm)Weight - 1.6-oz (45g) (without battery)
Software
- Trigger Indication - Colored LEDs and beeps
- Transmitter Indication - PAGE LED flashes Red, Green or Orange
- Positive Trigger Input
- LED Indicator - 'ZONE' LED flashes Green
- Audible Indicator - Beeps in groups of 9 for 1 minute
- Vibration Indicator - Vibrates in groups of 9 for 1 minute
- Negative Trigger Input 1
- LED Indicator - 'ZONE' LED flashes Red
- Audible Indicator - Beeps in groups of 9 for 1 minute
- Vibration Indicator - Vibrates in groups of 9 for 1 minute
- Negative Trigger Input 2
- LED Indicator - 'ZONE' LED flashes Orange
- Audible Indicator - Beeps in groups of 9 for 1 minute
- Vibration Indicator - Vibrates in groups of 9 for 1 minute
- Manual Page
- LED Indicator - 'ZONE' LED flashes Green
- Audible Indicator - Beeps in 3 groups of 3 for 1 minute
- Vibration Indicator - Vibrates in 3 groups of 3 for 1 minute
- Power ON
- LED Indicator - 'ZONE' LED will not be lit
- Audible Indicator - Beeps in 3 groups of 3 for 1 minute
- Vibration Indicator - Vibrates in 3 groups of 3 for 1 minute
- Low Battery Indicator - Beep/vibrate twice every 60 seconds or when switch is pushed
- Memory Indicator - Three continuous beeps/vibrates if no signals or at the end of all signals Beep/vibrate if the signal is an alarm page, will not beep/vibrate for manual page
- Unattended Page Indicator - Beep/vibrate once every 30 seconds after initial signal is received. Will continue to beep until switch is pushed